Step
8 Inside, get a tiny screwdriver and pry out (carefully)
your shift pattern inlay from the gear shifter. to reveal the nut inside.
Uscrew the shifter handle from the shaft.
Step
10 The kit comes with a small grommet/o-ring which you are
supposed to slip over the shaft. We reamed it out until it fit just
underneath the shifter handle. Once on, you then put the hand throttle
over it and tighten up the screw.
|
Step
9 Drill a small hole in the rubber gasket in the firewall.
Put one end of the black tubing into the bracket assembly by the throttle
body. Then, pass the black tubing through the hole and into the inside
of the Jeep. Run it through underneath your center console and up through
the accordian boot to the throttle.
Step
11 You'll need to cut one end off of the cable in order to
pass it through. Look closely and you'll notice that one end is attached
90 degrees differently than the other. Keep the one that attaches on
a flat side and cut off the one that attaches on a round edge. The cylinder
on the end will fit into the throttle in an inset hole. Try it to make
sure you do it right or you'll ruin the whole kit.
Step
12 |