Dana300 upgrades
I am planning to run 1350 drive shafts. I can get 1350 yokes for the stock outputs. Of you can spend the coin and get the 32 spline outputs. I am going to run a 2 piece front shaft. If I NEED better outputs, now is the time as the 26 spline yokes are $100/ea. Versus new 32...
Based on the measurements it should put the top of the shoulder higher than a low back and even higher than a prp base premier. More like a tall or a gt/se should belt height. No idea on the quality
So I wanted to simplify this as much as I could. My engine came from a Pontiac g6. I wanted to delete the oil cooler at the filter housing. Thru a little internet searching snd cross reference the engine I found a gm part that allows you to delete the cooler. Add plug in the block and viola, 2”...
for suspension, if you want simple, get the tuned springs from ORD. keep it tension shackle. I went thru the whole 48,52,56,63 spring combos, and in the end I would have rather had good, fresh springs from ORD that used nearly stock mounts. Crossover is a must.
For axles, DO a 60/14 bolt...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.