The Suzuki Jimny is known for its off-road performance, but the stock front axle swivel seal is prone to early failure. The OEM rubber seal quickly fails and lets damaging water and dirt in while allowing oil and grease to escape. Trail-Gear is proud to introduce the Trail-Safe™ Knuckle Ball Wiper Seal for the Suzuki Jimny. The Trail-Safe™ Knuckle Ball Wiper Seal is a dual-lipped wiper seal that keeps grease in and dirt out, all while eliminating the OEM swivel seal system. Since it is made from seal-grade polyurethane, not UHMW, the seal is pliable enough to stretch over the knuckle ball during installation. This eliminates the need to cut the seal for installation which creates a potential leak point. (more…)
Tag: Suzuki Jimny
-

Suzuki RHD High Steer Kit, Samurai & Jimny
The Trail-Gear Suzuki High Steer kit has been engineered specifically to work with stock Suzuki RHD Samurai and Jimny axles. This complete kit features solid forged 8620 steel steering arms, heavy duty 1 ¼" x .250" wall DOM Drag Link and Tie Rod, FJ80 tie rod ends and all necessary hardware. This kit even includes the hard-to- find 1:10 taper reamer for reaming out your stock Pitman arm! The Trail-Gear Suzuki RHD High Steer kit has been designed for easy installation. It is a must-have for a spring over axle set-up!
Available Options:
- Suzuki RHD High Steer Kit (Samurai/Jimny JB31), 304020-3- KIT, $313.95
- Suzuki RHD High Steer Kit (Jimny JA11), 304021-3- KIT, $313.95
-

Trail-Gear is now offering 4.16 and 4.90 Jimny T-Case Gears
This is the first and only true international gear set that includes all four gears necessary for your low range gear installation.
Low range gears are critical for technical off-road driving. Our Jimny T-Case Gears is the highest quality gear set available. Low Range reduction is 4.16:1 (84% low range reduction & 12% high range reduction) or 4.90:1 (115% low range reduction and 16% high range reduction). No welded or second rate, gears here. These are strong, run quiet and take a huge amount of abuse. This complete kit includes four new precision cut gears, counter shaft, needle bearings, shims, o-ring, gaskets, and input/output seals. Heavy duty front output shaft recommended (see below).
Note: The recommended tire size for the 4.16 gears is 29”-30” and 30”-31” for the 4.90 gears.
Note: Will not fit in Jimny chain-drive transfer cases.
Application Data:
1990-1995 Suzuki Jimny JA11 4WD
1995-1998 Suzuki Jimny JA12 4WD
1986-1990 Suzuki Jimny JA71 4WD
Available Options:
4.16 Jimny T-Case Gears, 303924-3-KIT, $418.95
4.90 Jimny T-Case Gears, 303925-3-KIT, $523.95
-

Trail-Gear is now offering a Suzuki Samurai/Jimny Rear Wheel Bearing Seal
This kit is perfect for replacing your worn out bearing and seals in your Suzuki Samurai or Suzuki Jimny. This Rear Wheel Bearing kit includes high quality, genuine Koyo brand bearings with integral spacer, ground bearing retainer, and an OEM quality Rear Axle Wheel Seal. We have also went one step further and included a full set of instructions. (more…)
