Recent content by whiterhino

My fuel pump is below and close to my cell. I've burned through 2 in the last 5 years and the current one is starting to whine. Not sure why other than I think with so much idling (crawling) the pump is always pushing a lot of fuel back to tank. I also have a shutoff at my tank and can drain...

Ahhh bummer. If it’s just small leaks maybe try Green Slime?

Great vid Matt. Where is that? Off topic, is the roof padding for noise, heat or just street cred? :) And does that little fan help much? To the OP, notice how his hand never gets further back than his thigh? If he had to reach further back, it would be awkward.

How close is your trans shifter to your knees? It looks like you will have to pull your elbow back behind / beside your seat bolster to reach the shifter. You want to be able to drop your hand off the wheel and have it naturally fall onto your trans shifter. (note Woody's, Matt's and mine is...

They work decent but probably not as good as direct linkage. I had to replace one early on. I attribute it to trying to force a shift vs finessing it. My double works flawlessly. Shifting to a front dig can be a nuisance sometimes but that is not unique to cable shifters. Quite often there...

No suggestion on tubes but........ how big is the cut in the sidewall? I've had some pretty big gashes vulcanized with good success. I did NOT have good success with Gluetread. Gotta do the hot vulcanizing to make it last.

Since I am a drag axle car, rear steer controls are a non factor. For me, levers touched by priority are transmission, rear air locker, cutting brakes and then transfer case. I lock and unlock my rear a lot and always unlock prior to cutting brake. My right hand is always on my trans shifter...

Do you use a TPMS? If so, which one. I ran the EEZtire monitor for years with no problems. I had two different towing scenarios (different number of tires and different pressures) and I figured I could just use whichever monitor I needed depending on what I was towing. So I bought a new...

Needs a pic with the buggy on it.

No pop up. Good job!

late to the party but testing again.

I've used a variety of mfg'rs and also some DIY. Lots of good names out there but I will never use High Angle again. JE Reel and Tom Woods are both know to support the sport very well. My rear is 2" or 2-1/4" or 2-1/2" with quarter wall with 1410 joints. (I don't remember without measuring)...

I'm pretty much stuck on my 43's. They work good for what I need.

testing OK no popup now. You fixed it but don't want to tell. :rolleyes: LOL

I just got burned by this too on the NP205 shave thread. I saw the popup after I posted so I posted again and apparently again. LOL Desktop with Brave. And agree, no way to delete a post.